Fandom

Raspberryhigh Wiki

MOSFET PWM driver

10pages on
this wiki
Add New Page
Comments0 Share
Pwm1

The built PWM driver board. DC in on spade lugs; 2 pin header for PWM signal; wire leads to heater. IRFZ48 is the MOSFET we chose due to its 0.04 ohm Ron.

Heatercircuit

The heater PWM driver circuit is very simple. The 0-5V PWM signal from the controller passes to Q2 to isolate and buffer it. Q2 drives the base of Q3, which acts as a signal inverter and gives us enough voltage to drive Q1. Q1 is a low on resistance MOSFET that allows current to pass through the heater when the gate is pulled high by Q3.

Ad blocker interference detected!


Wikia is a free-to-use site that makes money from advertising. We have a modified experience for viewers using ad blockers

Wikia is not accessible if you’ve made further modifications. Remove the custom ad blocker rule(s) and the page will load as expected.